搅拌车有时候会出现问题，是由于里面有很多的土渣没有清理干净，需要及时将内部的土渣清理出来，这样才能使它正常运行，接下来就教大家清理土渣的方法。
Sometimes there are problems with the mixer truck, because there are a lot of soil residues in it that are not cleaned up. It is necessary to clean up the internal soil residues in time in order to make it operate normally. Next, I will teach you how to clean up the soil residues.
方式一
Mode 1
1、准备好紧急驱动软管，将搅拌车熄火，卸下液压马达上的高压油管接头。
1. Prepare the emergency drive hose, turn off the mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.
2、将救援车熄火，将其液压马达的高压油管卸下，并与故障车上的对应接头用紧急驱动软管相连。
2. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor, and connect it with the corresponding connector on the faulty vehicle with an emergency drive hose.
3、发动救援车，将其操纵手柄拨出料位置，故障车内的混凝土即被排出。
3. Start the rescue vehicle, turn its joystick to the discharge position, and the concrete in the faulty vehicle will be discharged.
4、紧急驱动完毕后，将驱动软管卸下，并恢复两车原状。
4. After the emergency drive is completed, remove the drive hose and restore the two vehicles to their original state.
5、还有一种简单点的方法就是在托轮和滚道之间放入木楔，控制搅拌筒的旋转，将发动机熄火，拆松液压马达的一根高压油管，搅拌筒可自由旋转，控制搅拌筒的旋转，使维修孔转到下部，然后打开维修孔，清理出筒内混凝土。混凝土排出完毕后，恢复搅拌车原状。
5. Another simple method is to put a wooden wedge between the supporting wheel and the raceway, control the rotation of the mixing drum, shut down the engine, and loosen a high-pressure oil pipe of the hydraulic motor. The mixing drum can rotate freely, control the rotation of the mixing drum, turn the maintenance hole to the lower part, and then open the maintenance hole to clean the concrete in the drum. After the concrete is discharged, the mixer truck shall be restored to its original state.
方式二
Mode II
1、每天的工作结束后，将搅拌罐内注入适量的水，并保持搅拌罐缓慢旋转；
1. After the work every day, inject an appropriate amount of water into the mixing tank and keep the mixing tank rotating slowly;
2、将搅拌车水箱里的水加满，以保证清洗过程的水量充足；
2. Fill up the water tank of the mixer truck to ensure sufficient water in the cleaning process;
3、向罐体内注水，注水过程中保持搅拌罐工作状态，以足够的水量保证洗掉搅拌罐内残存的混凝土；
3. Inject water into the tank, maintain the working state of the mixing tank during the injection process, and ensure that the residual concrete in the mixing tank is washed with sufficient water;
4、打开洗车泵，接好高压水枪（高端搅拌车标配，有些厂家可能需要定制）；
4. Turn on the car wash pump and connect the high-pressure water gun (standard for high-end mixer trucks, some manufacturers may need to customize);
5、仔细清洗罐体、进料口、出料口、车身等残留物料；
5. Carefully clean residual materials such as tank body, feed inlet, discharge outlet and vehicle body;
6、确认没有水泥和混凝土结块后，将小型混凝土搅拌车的搅拌罐内污水放掉。
6. After confirming that there is no cement and concrete caking, drain the sewage in the mixing tank of the small concrete mixer.
搅拌车在每天使用后要及时清洗，以防止搅拌车罐内残存的混凝土凝固或者对设备造成腐蚀，以上就是搅拌车清洗土渣的方法，无论是选择哪种方法都要注意。更多内容就来我们网站http://www.zkzdsljbc.com吧！
The mixer truck should be cleaned in time after use every day to prevent the remaining concrete in the mixer truck tank from solidifying or causing corrosion to the equipment. The above is the method of cleaning soil residue by the mixer truck. No matter which method is selected, attention should be paid to safety. Come to our website for more information http://www.zkzdsljbc.com Come on!
