Before starting the mixer track, the operating handle of the mixer drum must be in the "stop" position.
搅拌车启动发动机后，应将搅拌鼓以低速旋转约10分钟，以便液压油温度在开始运行之前超过20°C。
After the mixer starts the engine, rotate the drum at a low speed for about 10 minutes so that the hydraulic oil temperature exceeds 20 ° C before starting operation.
如果搅拌车停在室外，则在装载前应颠倒搅拌桶，以排出水和碎屑，以确保混凝土质量。
If the mixer truck is parked outside, the mixing drum should be reversed before loading to drain water and debris to ensure the quality of concrete.
在搅拌车运输混凝土时，请确保滑动铲斗就位，以避免松动，行人受伤或摇摆，这可能会影响其他车辆的正常运行。
When transporting concrete by mixer truck, please ensure that the sliding bucket is in place to avoid loosening, pedestrian injury or swing, which may affect the normal operation of other vehicles. to
当搅拌车装载混合混凝土时，搅拌桶的速度为2-10 rpm。在运输过程中，在平坦路面上搅拌桶的速度保证为2-3 rpm。在超过50的侧坡上行驶和在左右摇摆较大的道路上行驶时，必须在路面状况得到改善后停止混合料灌浆并重新开始混合料灌浆。
When the mixer truck is loading the mixed concrete, the speed of the mixing drum is 2-10 rpm. During transportation, the speed of the mixing drum is guaranteed to be 2-3 rpm on the flat road. When driving on the side slope over 50 and on the road with large left-right swing, the mixture grouting must be stopped and restarted after the road condition is improved.
混凝土搅拌车运输混凝土的时间不得超过搅拌站规定的时间。在运输混凝土期间，请勿长时间停止搅拌桶，以防止混凝土偏析。
The time of transporting concrete by concrete mixer truck shall not exceed the time specified by mixing station. During the transportation of concrete, do not stop the mixing bucket for a long time to prevent concrete segregation.
如果搅拌车装有混凝土，则现场停滞时间不应超过一小时。如果时间已过去，现场人员将需要及时采取行动。
If the mixer truck is equipped with concrete, the dead time on site shall not exceed one hour. If time has passed, field personnel will need to take timely action.
搅拌车运输的混凝土块必须少8厘米。从混凝土进入储罐开始直排出为止，在炎热天气下排出不应超过2小时，在寒冷天气下排出不应超过2.5小时。
Concrete blocks transported by mixer truck must be at least 8 cm. From the beginning of concrete entering the storage tank to discharging, the discharging time shall not exceed 2 hours in hot weather and 2.5 hours in cold weather.
在搅拌车弹出混凝土之前，以10-12 rpm的速度旋转搅拌桶1分钟，然后弹出。
Before the concrete is ejected by the mixer truck, rotate the mixing drum at a speed of 10-12 rpm for 1 minute, and then eject.
混凝土搅拌机排干车后，立即使用卡车附带的软管冲洗入口，排水漏斗和排水槽，以排出车身上的灰尘或残留混凝土。将150-200L的清水倒入搅拌桶中。在返回的过程中，缓慢旋转搅拌桶以清洁内壁，防止炉渣粘附在搅拌桶壁和搅拌叶片上，加水并重新填充。
After the concrete mixer drains the truck, immediately flush the inlet, drain funnel and drain trough with the hose attached to the truck to remove dust or residual concrete from the truck body. Pour 150-200l clean water into the mixing bucket. In the process of returning, slowly rotate the mixing drum to clean the inner wall, prevent slag from adhering to the mixing drum wall and mixing blades, add water and refill.
